Author Topic: Poulan pro 5020 PR5020 Poulan 5020 4818  (Read 7088 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22135
  • Karma: 552
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan pro 5020
« Reply #10 on: February 27, 2013, 02:24:33 pm »
I couldnt stand it no more.    Just bought a  PP5020AV so I could run and check one out for myself.

Ha the curiosity finally got to you.   
Well I will be awaiting for what you think for a 50cc saw.

All I have read is that Mark said 5020 had less torque in the cut then the 330 and 330 was stronger. That is expected IMO considering the 5020 50cc and 330 54cc. 
 Just like the PP325 partner 5500 53cc is noticeably stronger and more torque in the cut then the partner 5000 49cc.
 or 45cc 346 compared to 50cc 346 same thing noticed.

I have a good running grey craftsman 49cc aka poulan 3000 with bare bore to compare to. 

1st thing I plan on doing is never installing the 20".  Going to put a 16" on from the get go in 3/8. Then maybe 325 later too since that is what the 3000 has on it. Will test with same set ups on both in 3/8 and 325.

What bar mount is on the 5020?  K041 or K095  ?
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
564 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
1281 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
9 Replies
357 Views
Last post July 09, 2013, 04:07:30 pm
by moparman texas
3 Replies
273 Views
Last post March 09, 2013, 06:49:38 pm
by Cut4fun .
5 Replies
287 Views
Last post October 01, 2020, 09:08:49 am
by Cut4fun .
11 Replies
483 Views
Last post March 16, 2014, 04:12:43 pm
by Cut4fun .
1 Replies
146 Views
Last post May 14, 2015, 03:29:42 pm
by 660magnum
10 Replies
322 Views
Last post April 27, 2016, 02:22:24 pm
by deezlfan
2 Replies
243 Views
Last post May 21, 2017, 08:59:45 pm
by Cut4fun .
8 Replies
229 Views
Last post December 31, 2018, 09:04:53 am
by Cut4fun .