Author Topic: Poulan pro 5020 PR5020 Poulan 5020 4818  (Read 6604 times)

0 Members and 2 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21878
  • Karma: 522
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan pro 5020
« Reply #50 on: March 04, 2013, 08:33:49 pm »
Kevin, if you really want to try a .325 setup, you could make a brass bushing to fit a PP295 clutch drum to the 5020. That is if I remember right! LOL

Seemed it was the same size drum, just that the crank dia was smaller on the 5020.

Just to get techical, the bar that comes on the 5020 would actually be considered a Z095 mount because it carries a non standard drive link count.

Me myself would leave it 3/8 and 16".  .

Really, then why did you ask about how to convert it to .325????


I said ME I would leave it 3/8  IF it were me going to run it and own it.   ;D

To test with I am going to try 325 too so IF OTHERS need info.  ::)     ::) ::)  It's really not that hard to comprehend is it?

REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
Poulan 505

Started by man of stihl « 1 2 ... 40 41 » Poulan

406 Replies
8314 Views
Last post July 05, 2020, 08:47:06 am
by Cut4fun
4 Replies
537 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
1188 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
9 Replies
356 Views
Last post July 09, 2013, 04:07:30 pm
by moparman texas
3 Replies
269 Views
Last post March 09, 2013, 06:49:38 pm
by Cut4fun .
11 Replies
472 Views
Last post March 16, 2014, 04:12:43 pm
by Cut4fun .
1 Replies
136 Views
Last post May 14, 2015, 03:29:42 pm
by 660magnum
10 Replies
312 Views
Last post April 27, 2016, 02:22:24 pm
by deezlfan
2 Replies
214 Views
Last post May 21, 2017, 08:59:45 pm
by Cut4fun .
8 Replies
210 Views
Last post December 31, 2018, 09:04:53 am
by Cut4fun .