« previous next »
Pages: [1] 2 3 4 5 6 ... 42   Go Down

Author Topic: Poulan 505  (Read 15324 times)

0 Members and 48 Guests are viewing this topic.

Offline man of stihl

  • Nitro Hotsaw
  • *******
  • Posts: 1219
  • Karma: 71
  • NW PA
  • Location: nw pennsylvania

    • Total Badges: 31
    Badges: (View All)
    Level 6 Fourth year Anniversary Spammer 25 Posts in one day Karma Good 1000 Posts Third year Anniversary
Re: Poulan 505 projects
« on: February 28, 2011, 06:42:33 pm »
i did a light port job on the cylinder tonight. both ports seemed real wide. about 2mm from piston witness lines so i left the sides alone. raised the roof in the exhaust a little. lowered the intake a little.cleaned out casting flaws in piston windows. replaced gasket with threebond 1194. put the cylinder back on. did a compression test got 150 psi. ;D ;D ;D.  i'll finish tomorrow i hope.
Logged
Ron
Pages: [1] 2 3 4 5 6 ... 42   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
224 Replies
17113 Views 		Last post November 04, 2023, 07:33:36 am
by Cut4fun .
4 Replies
1300 Views 		Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
3475 Views 		Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
Poulan 335

Started by 3000 FPS « 1 2 3 4 5 » Poulan

47 Replies
4068 Views 		Last post November 03, 2022, 08:55:06 am
by Cut4fun
Poulan 380

Started by Cut4fun . « 1 2 ... 7 8 » Poulan

79 Replies
5738 Views 		Last post June 18, 2022, 08:41:16 am
by Cut4fun .
poulan saw

Started by Jay Poulan

2 Replies
501 Views 		Last post May 24, 2013, 05:07:22 pm
by Cut4fun .
7 Replies
974 Views 		Last post September 10, 2023, 10:51:03 am
by Cut4fun .
2 Replies
792 Views 		Last post May 21, 2017, 08:59:45 pm
by Cut4fun .
9 Replies
1440 Views 		Last post March 25, 2023, 08:54:55 am
by Cut4fun
1 Replies
423 Views 		Last post May 29, 2021, 08:42:15 pm
by 3000 FPS