Author Topic: Poulan Wild Thing 18in Bar  (Read 346 times)

0 Members and 0 Guests are viewing this topic.

Offline oldpart

  • 3 cube
  • *
  • Posts: 11
  • Karma: 3
Re: Poulan Wild Thing 18in Bar
« on: January 30, 2013, 08:49:25 am »
At one point in time, Poulan had fan housings that were incorrectly molded. The back side of the pulley would drag on a narrow ridge on the housing. I see about one of these a month. We usually just replace the housing, but you can cut the ridge down with a dremel. We see several that the pulley and housing actually melt and weld together.

 

Related Topics

  Subject / Started by Replies Last post
13 Replies
1187 Views
Last post February 09, 2013, 09:08:05 am
by farmboy
27 Replies
957 Views
Last post March 12, 2020, 10:52:36 am
by Cut4fun .
16 Replies
411 Views
Last post September 20, 2013, 05:17:00 pm
by Cut4fun
5 Replies
596 Views
Last post August 27, 2015, 02:22:03 pm
by Cut4fun .
9 Replies
303 Views
Last post February 02, 2014, 10:24:24 am
by countryhog
4 Replies
339 Views
Last post April 22, 2014, 08:57:25 am
by KilliansRedLeo
7 Replies
273 Views
Last post September 30, 2015, 07:01:05 pm
by treeslayer2003
Wild Thing

Started by Cut4fun « 1 2 » Poulan

16 Replies
350 Views
Last post August 15, 2014, 06:58:19 pm
by WildThang098
7 Replies
274 Views
Last post January 31, 2016, 03:15:43 pm
by 3000 FPS
7 Replies
185 Views
Last post January 31, 2018, 03:02:37 pm
by Cut4fun .