Author Topic: Poulan XX or Poulan 20  (Read 215 times)

0 Members and 0 Guests are viewing this topic.

Offline dthorn

  • pruner
  • *
  • Posts: 2
  • Karma: 0
Poulan XX or Poulan 20
« on: May 29, 2021, 07:28:09 pm »
I have an auction find Poulan XX slash Craftsman 1.9A.  I rebuilt the carb, replace fuel and oil lines.  Now the fuel runs straight out of the bar lube hose.  Yes, I put it in the right reservoir!

Also, right after this, it would POP (with gas flying everywhere) and now it won't do anything.  I tried a shot of starter spray to no avail.  Voltage from plug wire to end of plug seems to be 4-6V if I am reading it fast enough.

Please help or should I dump.

Share on Facebook Share on Twitter


Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4668
  • Karma: 316
  • Location: Carpenter, Wyoming
Re: Poulan XX or Poulan 20
« Reply #1 on: May 29, 2021, 08:42:15 pm »
I was just looking up some specs on acres site and it does show piston ported.   I thought it might have been a reed valve but no. 
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
Poulan 505

Started by man of stihl « 1 2 ... 41 42 » Poulan

414 Replies
13160 Views
Last post December 08, 2020, 07:49:03 am
by Cut4fun
Poulan 475

Started by Cut4fun « 1 2 ... 35 36 » Poulan

355 Replies
33613 Views
Last post November 18, 2022, 07:43:07 am
by Cut4fun .
Poulan 415

Started by Cut4fun « 1 2 ... 11 12 » Poulan

117 Replies
6403 Views
Last post November 27, 2021, 07:43:33 am
by Cut4fun .
Poulan 365

Started by Cut4fun « 1 2 ... 16 17 » Poulan

169 Replies
8264 Views
Last post January 31, 2018, 07:59:31 pm
by stubnail67
223 Replies
13741 Views
Last post December 12, 2020, 07:44:04 am
by Cut4fun
4 Replies
988 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
2489 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
5 Replies
614 Views
Last post October 01, 2020, 09:08:49 am
by Cut4fun .
2 Replies
582 Views
Last post May 21, 2017, 08:59:45 pm
by Cut4fun .
2 Replies
245 Views
Last post June 12, 2020, 10:13:07 am
by Cut4fun .