Author Topic: PP5020 RPM Settings Needed  (Read 363 times)

0 Members and 0 Guests are viewing this topic.

Offline Jason K

  • 6 cube
  • ****
  • Posts: 190
  • Karma: 7
  • Location: Iowa
PP5020 RPM Settings Needed
« on: July 29, 2014, 11:57:01 pm »
I got a PP5020 in too set the rpms. I would like to know the settings.

Thanks
Jason

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21879
  • Karma: 522
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: PP5020 RPM Settings Needed
« Reply #1 on: July 30, 2014, 09:54:10 am »
13K  I liked mine around 12.8K

When I got mine new.
I checked factory settings and then put them back to see. L was 1.5 and H was 2 - 2.5 out (sorry cant remember H off hand).

It would start and not idle and shut off. Start and bog giving throttle.

I kept adjusting the carb till I ended up with about 3 out on L and left 2-2.5 on H at about 12.8K. Turned the I idle up too.  Not like the 1 to 1.5 turns out we get used to.

Thread on poulan 5020. http://chainsawrepair.createaforum.com/poulan/poulan-pro-5020/
REDNECK Saw Repair Getter Done

Offline Jason K

  • 6 cube
  • ****
  • Posts: 190
  • Karma: 7
  • Location: Iowa
Re: PP5020 RPM Settings Needed
« Reply #2 on: July 30, 2014, 09:10:59 pm »
Thanks for the info.

Jason

Online 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4460
  • Karma: 273
  • Location: Carpenter, Wyoming
Re: PP5020 RPM Settings Needed
« Reply #3 on: July 31, 2014, 01:06:25 am »
13K, that is not bad.   I did not know they tuned that high of RPM.   
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
0 Replies
493 Views
Last post February 27, 2011, 12:24:14 am
by Cut4fun .
14 Replies
1259 Views
Last post August 31, 2014, 09:48:06 am
by Cut4fun .
5 Replies
788 Views
Last post October 01, 2012, 06:29:08 pm
by Cut4fun .
2 Replies
382 Views
Last post July 17, 2014, 02:55:38 pm
by circe
2 Replies
478 Views
Last post October 15, 2014, 05:49:59 am
by Little Al
3 Replies
154 Views
Last post December 19, 2015, 06:28:52 pm
by farmboy
5 Replies
1192 Views
Last post February 23, 2016, 11:10:39 am
by countryhog
4 Replies
367 Views
Last post June 28, 2017, 04:42:13 pm
by flyingdg
5 Replies
211 Views
Last post April 05, 2018, 09:26:50 am
by Cut4fun .
4 Replies
76 Views
Last post May 15, 2020, 07:11:28 am
by Cut4fun .