« previous next »
Pages: [1]   Go Down

Author Topic: PP5020 RPM Settings Needed  (Read 1432 times)

0 Members and 36 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23740
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

    • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: PP5020 RPM Settings Needed
« on: July 30, 2014, 09:54:10 am »
13K  I liked mine around 12.8K

When I got mine new.
I checked factory settings and then put them back to see. L was 1.5 and H was 2 - 2.5 out (sorry cant remember H off hand).

It would start and not idle and shut off. Start and bog giving throttle.

I kept adjusting the carb till I ended up with about 3 out on L and left 2-2.5 on H at about 12.8K. Turned the I idle up too.  Not like the 1 to 1.5 turns out we get used to.

Thread on poulan 5020. http://chainsawrepair.createaforum.com/poulan/poulan-pro-5020/
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
0 Replies
674 Views 		Last post February 27, 2011, 12:24:14 am
by Cut4fun .
14 Replies
1741 Views 		Last post August 31, 2014, 09:48:06 am
by Cut4fun .
5 Replies
1658 Views 		Last post October 01, 2012, 06:29:08 pm
by Cut4fun .
2 Replies
619 Views 		Last post July 17, 2014, 02:55:38 pm
by circe
2 Replies
1012 Views 		Last post October 15, 2014, 05:49:59 am
by Little Al
3 Replies
388 Views 		Last post December 19, 2015, 06:28:52 pm
by farmboy
5 Replies
2425 Views 		Last post February 23, 2016, 11:10:39 am
by countryhog
4 Replies
1858 Views 		Last post June 28, 2017, 04:42:13 pm
by flyingdg
5 Replies
4540 Views 		Last post April 05, 2018, 09:26:50 am
by Cut4fun .
4 Replies
918 Views 		Last post May 15, 2020, 07:11:28 am
by Cut4fun .