« previous next »
Pages: 1 [2] 3   Go Down

Author Topic: Craftsman 358357180  (Read 1314 times)

0 Members and 59 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Craftsman 358357180
« Reply #10 on: January 08, 2020, 11:30:24 pm »
I would never run 50-1 either.    You know it is not only the cylinder and rings that depend on that oil but the rod bearings and crank bearings.
There have been some early failures on bearings because of the lack of oil. 
Logged
PP 505, 475, 445.
Like Like x 1 Agree Agree x 1 View List
Pages: 1 [2] 3   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
2 Replies
1713 Views 		Last post July 18, 2012, 01:40:02 pm
by Cut4fun .
5 Replies
793 Views 		Last post February 11, 2014, 03:36:38 pm
by Cut4fun
3 Replies
1349 Views 		Last post July 13, 2015, 12:41:04 am
by Eccentric
2 Replies
634 Views 		Last post September 23, 2014, 07:29:34 pm
by Cut4fun .
5 Replies
873 Views 		Last post March 06, 2017, 09:49:31 pm
by 3000 FPS
16 Replies
1434 Views 		Last post February 15, 2016, 11:25:49 pm
by dannyupsolate
1 Replies
932 Views 		Last post April 03, 2016, 12:34:02 pm
by Cut4fun .
7 Replies
577 Views 		Last post February 22, 2022, 09:21:51 am
by Cut4fun .
2 Replies
183 Views 		Last post December 13, 2019, 10:47:47 am
by highland_hunter
3 Replies
368 Views 		Last post May 07, 2020, 10:00:44 pm
by Super360