« previous next »
Pages: [1]   Go Down

Author Topic: Slow starting 3400  (Read 345 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23514
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Slow starting 3400
« on: February 20, 2013, 04:39:47 pm »
I pulled the muffler to get a better look at it from other side too.

IMO if you can clean that bevel on exhaust where ring etc hit you will be good to go IMO. I would just take some emery clothe and or scotch brite pad and clean cylinder up after fixing the bevel area.




Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
17 Replies
739 Views 		Last post December 13, 2013, 09:51:21 am
by adam32
MS290 won't run slow

Started by jvh24521 « 1 2 3 » Stihl

25 Replies
858 Views 		Last post March 11, 2014, 03:29:25 pm
by jvh24521
0 Replies
288 Views 		Last post April 01, 2014, 02:24:11 pm
by Cut4fun
21 Replies
797 Views 		Last post July 27, 2014, 06:12:27 pm
by JohnG28
2 Replies
334 Views 		Last post July 06, 2014, 08:25:56 am
by bardos
17 Replies
1773 Views 		Last post September 15, 2014, 12:30:02 pm
by 660magnum
30 Replies
992 Views 		Last post November 02, 2014, 11:32:40 am
by TommyC
0 Replies
188 Views 		Last post June 20, 2015, 12:02:22 pm
by Cut4fun .
6 Replies
1456 Views 		Last post December 23, 2016, 04:52:43 am
by DNX800
6 Replies
415 Views 		Last post August 28, 2017, 01:01:34 am
by tfox1994