Author Topic: Poulan 3450 Badboy Tim Allen TA BB  (Read 2128 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Tim Allen 3450 Poulan Bad Boy
« on: January 20, 2013, 08:53:04 pm »
I hear ya, and I already have I think 3, 3450's and really do not need another unless of course the price was right.  Now if it was a 3750 it would have been gone.

Yep.  I have a nice PP330 (although I'm STILL waiting on backordered parts for it from Baileys.......GRRRR).  Would like to land a nice 3750,  PP380, or 3450 T3 to run alongside the 330.  If I can get a 3450/PP330 cheap enough to make buying a new PP380 top end for it, then that'd be cool too.:D
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
242 Replies
7780 Views
Last post March 23, 2020, 06:17:53 pm
by Cut4fun .
Poulan 330 3450

Started by Cut4fun . « 1 2 ... 33 34 » Poulan

330 Replies
9942 Views
Last post March 03, 2020, 03:15:53 pm
by Cut4fun .
3 Replies
347 Views
Last post February 03, 2013, 06:33:10 pm
by 660magnum
Poulan 3450 60cc

Started by Cut4fun . « 1 2 ... 6 7 » Poulan

66 Replies
1379 Views
Last post February 08, 2018, 07:01:11 pm
by 3000 FPS
Poulan 3450 Carb issues

Started by rockfishon « 1 2 ... 7 8 » Poulan

77 Replies
1081 Views
Last post August 27, 2015, 07:55:47 pm
by Eccentric
5 Replies
328 Views
Last post October 23, 2014, 06:53:51 pm
by Cut4fun .
2 Replies
179 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
8 Replies
215 Views
Last post June 05, 2015, 09:52:30 am
by Cut4fun .
Poulan 3450 54cc 60cc

Started by Cut4fun « 1 2 3 4 5 » Poulan

43 Replies
717 Views
Last post November 02, 2015, 10:59:12 am
by Cut4fun .
2 Replies
135 Views
Last post February 28, 2018, 01:25:07 pm
by Cut4fun .