« previous next »
Pages: 1 [2]   Go Down

Author Topic: Making A Twin  (Read 2819 times)

0 Members and 38 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181

    • Total Badges: 34
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 6 Seventh year Anniversary Sixth year Anniversary
Re: Making A Twin
« Reply #10 on: February 14, 2012, 08:28:29 pm »
I had always assumed because I've never seen it done that the counter weights or crankshaft halves where heated with an induction heater  or some other method before they were pressed . That hammer deal is basically how they do a Harley crank . It would be a job is about all I can say,wow .
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
659 Views 		Last post November 09, 2012, 07:26:51 pm
by David Young
1 Replies
532 Views 		Last post February 05, 2014, 08:38:42 pm
by Cut4fun .
15 Replies
1209 Views 		Last post April 03, 2014, 09:16:44 pm
by Al Smith
8 Replies
714 Views 		Last post May 21, 2014, 12:54:52 pm
by dutchsawdoctor
9 Replies
723 Views 		Last post November 22, 2015, 03:26:05 pm
by mcbob
5 Replies
837 Views 		Last post June 13, 2016, 09:07:30 pm
by Al Smith
0 Replies
623 Views 		Last post July 27, 2016, 02:49:16 pm
by bill saf
7 Replies
1093 Views 		Last post February 25, 2017, 03:59:30 am
by dutchsawdoctor
2 Replies
588 Views 		Last post March 29, 2017, 11:57:45 am
by dutchsawdoctor
2 Replies
550 Views 		Last post January 22, 2023, 08:35:29 am
by Cut4fun .