« previous next »
Pages: 1 2 3 4 5 6 [7]   Go Down

Author Topic: Redmax 621  (Read 9122 times)

0 Members and 1 Guest are viewing this topic.

Offline nenicu

  • 4 cube
  • **
  • Posts: 65
  • Karma: 7
Re: Redmax 621
« Reply #60 on: January 12, 2016, 12:32:31 pm »
The Zenoah gasket was just like the isolator. A big restriction from the factory.I did a little porting on the cylinder,but working with a chain file is slow. And you don't get the same results like the defunct dremel.
Logged

Offline nenicu

  • 4 cube
  • **
  • Posts: 65
  • Karma: 7
Re: Redmax 621
« Reply #61 on: January 16, 2016, 01:00:06 pm »
 Today i assembled my Zenoah Komatsu  G621 avs. I think is an older model because on the right side has only 2 av mounts.
Logged

Offline nenicu

  • 4 cube
  • **
  • Posts: 65
  • Karma: 7
Re: Redmax 621
« Reply #62 on: January 16, 2016, 01:02:45 pm »
More
Logged

Offline Chris-PA

  • 6 cube
  • ****
  • Posts: 209
  • Karma: 32
Re: Redmax 621
« Reply #63 on: January 16, 2016, 04:50:58 pm »
Interesting - and unfortunate - about that missing A/V mount.  I know on my clone that when I tore that mount the saw was much more floppy.  It was quite obvious.  I hope it's not a problem on yours. 
Logged
Pages: 1 2 3 4 5 6 [7]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
1 Replies
757 Views 		Last post July 21, 2014, 07:51:39 pm
by Cut4fun .
Redmax gone Chinese?

Started by brettl « 1 2 » RedMax

14 Replies
4740 Views 		Last post March 15, 2015, 11:26:18 am
by SawTroll
0 Replies
920 Views 		Last post March 15, 2015, 03:15:03 pm
by Cut4fun .
3 Replies
1356 Views 		Last post January 30, 2016, 09:59:03 am
by rburg
7 Replies
1772 Views 		Last post June 16, 2016, 11:30:27 pm
by 166
0 Replies
205 Views 		Last post June 01, 2016, 07:39:40 am
by RobbinW
0 Replies
712 Views 		Last post December 24, 2016, 10:32:06 pm
by farmboy
1 Replies
1052 Views 		Last post February 15, 2017, 09:47:55 am
by rburg
3 Replies
1209 Views 		Last post April 28, 2018, 06:52:44 pm
by J.Walker
3 Replies
635 Views 		Last post August 07, 2018, 03:53:25 pm
by Cut4fun .