« previous next »
Pages: [1] 2   Go Down

Author Topic: OK i will go first Shindaiwa 695  (Read 5188 times)

0 Members and 0 Guests are viewing this topic.

Offline danb137

  • pruner
  • *
  • Posts: 4
  • Karma: 1
Re: OK i will go first Shindaiwa 695
« on: December 04, 2013, 10:37:52 pm »
hello im new to this forum i am in the process of rebuilding my 695 and got a shindiawa cylinder and it is not plated in the bore, like sand blasted aluminum ??? any one run into this.  the piston fits very well with the rings on it, im just confused the saw is not a pos you would think it would be plated. please help thanks!
Logged
Pages: [1] 2   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
0 Replies
75 Views 		Last post December 06, 2013, 09:40:23 am
by danb137
0 Replies
838 Views 		Last post May 06, 2014, 04:48:17 am
by fordfairlane78
2 Replies
1021 Views 		Last post January 25, 2015, 10:19:07 am
by 67L36Driver
13 Replies
1395 Views 		Last post October 11, 2015, 12:02:40 am
by aclarke
5 Replies
427 Views 		Last post February 29, 2016, 04:53:43 pm
by fuzz1500
1 Replies
351 Views 		Last post February 12, 2016, 09:13:00 am
by fuzz1500
2 Replies
1115 Views 		Last post February 14, 2017, 07:27:30 pm
by RoyM
3 Replies
1172 Views 		Last post August 15, 2018, 11:16:33 am
by Cut4fun .
0 Replies
505 Views 		Last post November 10, 2020, 07:05:19 am
by Cut4fun .
0 Replies
231 Views 		Last post November 21, 2021, 07:07:58 am
by Cut4fun