« previous next »
Pages: [1] 2 3   Go Down

Author Topic: Honing ball Hone etc  (Read 3062 times)

0 Members and 21 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Honing ball Hone etc
« on: February 17, 2017, 02:40:47 pm »
I have ground on a few cylinders with a flex shaft and a burr and it would seem to me that you run a higher risk of chipping the plating on the edge of a port with a burr than you would with a ball hone.
Logged
PP 505, 475, 445.
Agree Agree x 1 View List
Pages: [1] 2 3   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
3 Replies
713 Views 		Last post February 02, 2012, 08:31:26 pm
by North West Farmer
8 Replies
689 Views 		Last post January 03, 2013, 06:42:14 pm
by Al Smith
5 Replies
741 Views 		Last post December 19, 2013, 09:10:40 am
by doreadeal
1 Replies
395 Views 		Last post September 21, 2015, 09:17:20 pm
by 660magnum
9 Replies
1389 Views 		Last post January 17, 2016, 11:12:18 pm
by Chris-PA
1 Replies
693 Views 		Last post March 03, 2018, 09:19:29 am
by Cut4fun .