« previous next »
Pages: [1]   Go Down

Author Topic: 009 carb linkage question  (Read 174 times)

0 Members and 0 Guests are viewing this topic.

Offline nortryder

  • pruner
  • *
  • Posts: 2
  • Karma: 0
009 carb linkage question
« on: March 31, 2013, 07:40:15 pm »
Can anyone advise as how to install the carb linkage to the carb. I took mine apart to rebuild the carb and didn't take any pictures. Bad,bad,bad.
Logged

Share on Facebook Share on Twitter

Offline Remington

  • 5 cube
  • ***
  • Posts: 110
  • Karma: 2
Re: 009 carb linkage question
« Reply #1 on: March 31, 2013, 09:51:03 pm »
I was in the same boat a few weeks ago.  There are only 4 options and 2 of them are fairly obvious and don't fit. I think if you try all the possible ways you will figure it out. I believe the right angle bend was on the bottom
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
2 Replies
442 Views 		Last post March 02, 2012, 09:54:14 am
by 2spud
1 Replies
183 Views 		Last post December 24, 2012, 05:30:19 am
by Al Smith
14 Replies
350 Views 		Last post January 26, 2013, 01:38:18 pm
by mdavlee .
36 Replies
911 Views 		Last post July 16, 2014, 07:18:19 pm
by Cut4fun
12 Replies
586 Views 		Last post September 25, 2013, 09:27:52 pm
by Vance in AK
6 Replies
342 Views 		Last post September 26, 2013, 03:16:07 pm
by sharkey
5 Replies
135 Views 		Last post May 04, 2015, 11:29:40 pm
by 3000 FPS
20 Replies
1075 Views 		Last post May 19, 2017, 04:08:15 am
by sharkey
2 Replies
219 Views 		Last post January 03, 2017, 12:24:00 pm
by rayvil01
7 Replies
219 Views 		Last post December 22, 2017, 05:49:10 am
by rayvil01