Chainsaw Repair

I suppose anything is possible. However the 028 is "old school " design. It's the little brother to the 048-042- 038 series . So I doubt the cylinder would be a direct bolt on thing .

You know it probably is about the same as a few that bolted 038 Mag cylinders on an 038 Av .You have to do some machine work for it to work .You'd just as well start off with the Mag to begin with rather than hill billy engineer one .

On the other hand if you have a pile of parts sitting around it might not be a bad project just to see if it would work .

As far as the 028 somebody had a screamer over in Pa. a few years back so they will run with some attention .On that I have one in the shed I'll do exactly that once I feel the ambition which has been rather lax here of late .