Author Topic: 026 dies when on its side  (Read 1677 times)

0 Members and 8 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna

  • Total Badges: 29
    Badges: (View All)
    2000 post CR Staff One year Anniversary 1000 Posts Never Sleep Group
Re: 026 dies when on its side
« Reply #10 on: November 04, 2013, 04:12:06 pm »
I actually had one in here that was doing the same thing, turned out that after ordering the lines, kit etc as was suggested by FISH, it was a mis-routed plug wire that had **** and was grounding out on the jug when the saw was turned bar-side down. I figured this out by removing the top cover, starting the saw, turning out the shop lights, then turning the saw on its' side while running. You could actually see the HT charge jump out of the plug wire and go directly to the cylinder. The mis-routing of the plug wire was the route cause of the problem since it allowed the wire to rub on the case when the saw was running. The SM shows the correct routing on the wire, in case you want to check.
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

 

Related Topics

  Subject / Started by Replies Last post
17 Replies
2033 Views
Last post February 12, 2013, 07:48:58 am
by bassman
9 Replies
1481 Views
Last post October 26, 2013, 10:25:33 pm
by 660magnum
7 Replies
732 Views
Last post December 01, 2014, 11:04:56 pm
by 660magnum
7 Replies
1004 Views
Last post October 29, 2014, 03:58:59 pm
by Fish
6 Replies
860 Views
Last post February 27, 2015, 02:12:00 pm
by adriandwor
8 Replies
1249 Views
Last post April 06, 2015, 06:56:20 pm
by Nathaniel Vansickle
16 Replies
1789 Views
Last post October 25, 2015, 09:19:53 pm
by mikehonda
1 Replies
408 Views
Last post December 01, 2015, 11:24:23 pm
by Cut4fun .
2 Replies
405 Views
Last post August 17, 2019, 10:53:09 pm
by Midpines
1 Replies
466 Views
Last post April 01, 2022, 07:50:25 am
by Cut4fun .