Author Topic: 028 carb issues  (Read 161 times)

0 Members and 0 Guests are viewing this topic.

Offline 295tramp

  • 3 cube
  • *
  • Posts: 12
  • Karma: 1
028 carb issues
« on: January 07, 2014, 08:07:46 pm »
Howdy I have a tillitston HU 40 and I just installed a complete carb kit in it.
my question is what is the level that the metering arm should be?
Plus this 028 has points and cond and it is getting spark but looks weak.
The last one I worked on I just changed out the electronics and installed a 029 coil and that worked great.
I'm wondering if a coil off a 440 mag would interchange? It looks the same size and the 440 flywheel has the same polarity. ???
Thanks abunch

Share on Facebook Share on Twitter


Offline jmester

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2046
  • Karma: 156
  • Location: MD
Re: 028 carb issues
« Reply #1 on: January 07, 2014, 11:00:02 pm »
The metering lever should be be level with the lower recessed area. Not with the gasket mating area.  The ignition module from a 440 mag should work for what you are looking for. The 029 and 440 share the same coil. Part # 0000 400 1300. The coil for an 460 and 660 are the same but won't work on the others for timing reasons. That part # 1122 400 1314.
FEAR NO TREE. FEAR GOD.

 

Related Topics

  Subject / Started by Replies Last post
13 Replies
3488 Views
Last post January 25, 2012, 07:21:50 pm
by Al Smith
5 Replies
749 Views
Last post February 21, 2012, 01:29:32 pm
by 660magnum
35 Replies
1067 Views
Last post November 11, 2016, 11:28:35 pm
by pete
17 Replies
658 Views
Last post September 15, 2014, 12:30:02 pm
by 660magnum
Poulan 3450 Carb issues

Started by rockfishon « 1 2 ... 7 8 » Poulan

77 Replies
1081 Views
Last post August 27, 2015, 07:55:47 pm
by Eccentric
5 Replies
401 Views
Last post June 21, 2015, 12:59:48 pm
by Cut4fun .
3 Replies
270 Views
Last post June 30, 2015, 07:11:44 pm
by Jason K
4 Replies
253 Views
Last post November 30, 2015, 08:11:00 pm
by 3000 FPS
11 Replies
347 Views
Last post December 07, 2015, 09:34:54 am
by weimedog
21 Replies
411 Views
Last post December 06, 2016, 03:13:16 pm
by Cut4fun .