Author Topic: 034 Rebuild  (Read 224 times)

0 Members and 0 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2745
  • Karma: 163
Re: 034 Rebuild
« Reply #10 on: January 28, 2020, 10:21:28 pm »
I have a set of nylon drifts which are similar I use to install the circlips .The smaller diameter fits in the hollow of the pin,the larger shoves the clip in .To get a stubborn pin loose I use a 1/4" drive socket extension and tap it with a nylon hammer .I also have a few drifts that are make of aluminum .
Another tip I do,don't spare the oil,I mean drown it .If on a cold new start if that engine doesn't blow smoke about 5 minutes I worry I didn't use enough .
Like Like x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
367 Views
Last post June 30, 2012, 10:04:41 am
by mgshiho
8 Replies
593 Views
Last post February 01, 2013, 03:10:13 pm
by 660magnum
394 Rebuild and BB

Started by alsled « 1 2 ... 5 6 » Husqvarna

51 Replies
862 Views
Last post June 13, 2014, 10:49:39 pm
by KilliansRedLeo
2 Replies
128 Views
Last post February 15, 2015, 03:08:29 pm
by wild262
13 Replies
258 Views
Last post July 30, 2015, 02:19:37 pm
by countryhog
2165 Rebuild

Started by mdavlee . « 1 2 3 » Jonsered

22 Replies
807 Views
Last post January 09, 2016, 11:33:44 am
by mdavlee .
3 Replies
300 Views
Last post June 11, 2016, 06:27:34 pm
by leec
6 Replies
199 Views
Last post August 15, 2017, 09:45:26 pm
by wild262
024 rebuild top end

Started by leec « 1 2 3 » Stihl

21 Replies
368 Views
Last post October 23, 2018, 09:28:42 pm
by leec
2 Replies
25 Views
Last post Today at 10:59:33 am
by 3000 FPS