Chainsaw Repair

The heat shrink I bought comes in long rolls and you cut to length.   I'll look to make sure and correct if needed.

that's exactly like the stuff we can get at princess auto (their web site sucks imo). i sometimes find it too thin for some repairs and need to double it up. i know at leading edge hobbies they have 2'-3' foot rolls in various diameters, thickness and heat parameters (different temps to shrink the tubing). i like the thicker tubing as you can put it and the wire into a shape, shrink the tubing and they will stay in that shape. really good on some kill switches

I have never had any problems with aftermarket fuel and impulse lines/intake boots  i use a lot of them. You hear a lot of storys about problems with top ends i dont seem to have any trouble. Most of my personal saws have aftermarket top ends, fuel lines etc. and they run almost daily
The only problem i have had was a golf piston had an indexing pin come out. I will say dont buy aftermarket husky kill switches they are total junk

                                                              BILL

pop the fuel cap open and see what line you have. either curved or straight. i think they will interchange if the opening for the line is the same size.

I have one of these 034AV units that should hate me by now but I can't kill it.. The power to weight ratio is pretty impressive.
 ( Made in West Germany )