« previous next »
Pages: [1] 2 3 4 5   Go Down

Author Topic: 066 bench racing. trying to get large torque gain? (long).  (Read 2661 times)

0 Members and 39 Guests are viewing this topic.

Offline aclarke

  • Nitro Hotsaw
  • *******
  • Posts: 1676
  • Karma: 172

    • Total Badges: 25
    Badges: (View All)
    Fourth year Anniversary Third year Anniversary 1000 Posts Second year Anniversary Level 5 500 Posts
Re: 066 bench racing. trying to get large torque gain? (long).
« on: February 02, 2014, 12:24:53 am »
Stroking the two piece stihl cranks is a pain, but stroking and a smaller bore would be a good start. Using some epoxy to "tighten" up the transfers and perhaps drop them a few degrees.  re-cut the squish for optimum squish velocity at target rpm.  Increase compression, and use higher velocity intake/carb tract along with timing advance if the Motor will take it. small sprocket too. Who has a small engine dyno ? Be a cool project! Adam'
Logged
Pages: [1] 2 3 4 5   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
0 Replies
487 Views 		Last post March 24, 2011, 02:13:57 pm
by Old Iron Logging
15 Replies
3156 Views 		Last post August 06, 2018, 06:43:58 pm
by Old Iron Logging
678 Replies
19504 Views 		Last post July 28, 2023, 08:57:26 am
by Cut4fun
Long Bar Mac

Started by Cut4fun . « 1 2 » McCulloch

19 Replies
1223 Views 		Last post July 12, 2013, 08:19:58 pm
by Al Smith
13 Replies
1261 Views 		Last post March 17, 2014, 07:18:35 pm
by Al Smith
3 Replies
691 Views 		Last post February 12, 2018, 12:48:21 pm
by HolmenTree
3 Replies
558 Views 		Last post April 21, 2019, 10:33:04 am
by 3000 FPS
0 Replies
350 Views 		Last post July 16, 2019, 04:27:56 pm
by HUSKY KEV
1 Replies
391 Views 		Last post March 15, 2021, 08:02:04 pm
by 3000 FPS
0 Replies
148 Views 		Last post December 05, 2022, 12:21:57 am
by FreakyLapidus