« previous next »
Pages: 1 [2]   Go Down

Author Topic: Aftermarket cylinder and piston for MS250?  (Read 936 times)

0 Members and 0 Guests are viewing this topic.

Offline ECpirates96

  • 3 cube
  • *
  • Posts: 9
  • Karma: 0
Re: Aftermarket cylinder and piston for MS250?
« Reply #10 on: January 24, 2012, 08:47:59 am »
I got it broke down last night and the piston is toast but the crank, bearlings and rod look fine. Looks like one I get the new piston and rings in I may have a good engine.
Logged

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181
Re: Aftermarket cylinder and piston for MS250?
« Reply #11 on: January 24, 2012, 09:24:05 am »
Well now it depends on what side of the piston is damaged .If it's scuffed on the intake side it ate too much dust .If it got burnt on the exhaust side it's either sucking air or somebody tried to lean it out like a model air plane engine with some misinformed information it would run better .

Most times if it's cooked on the exhaust side  it does irrepairable damage to the cylinder but not in all cases .
Logged

Offline ECpirates96

  • 3 cube
  • *
  • Posts: 9
  • Karma: 0
Re: Aftermarket cylinder and piston for MS250?
« Reply #12 on: January 26, 2012, 09:09:40 am »
I can feel it a little on the exahust side but it doesn't look or feel bad. I am going to scotch brite pad it and try a pistin and rings and see what I have then. Thanks
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
687 Views 		Last post August 02, 2012, 04:06:14 pm
by splitpost
6 Replies
632 Views 		Last post June 25, 2014, 11:06:00 pm
by aclarke
5 Replies
466 Views 		Last post January 22, 2014, 02:46:36 pm
by danders
17 Replies
801 Views 		Last post May 12, 2014, 12:40:25 am
by sharkey
6 Replies
435 Views 		Last post June 09, 2014, 08:05:24 pm
by Cut4fun .
21 Replies
1171 Views 		Last post November 29, 2014, 08:29:17 am
by weimedog
12 Replies
538 Views 		Last post December 15, 2014, 05:25:46 am
by Eccentric
5 Replies
839 Views 		Last post October 30, 2015, 04:48:09 pm
by dboyd351
8 Replies
469 Views 		Last post December 22, 2015, 12:16:44 pm
by waynec
0 Replies
64 Views 		Last post December 22, 2022, 07:56:33 am
by Cut4fun