Author Topic: Av28 wood boss runs 5 minutes & dies  (Read 276 times)

0 Members and 0 Guests are viewing this topic.

Offline ba_50

  • 3 cube
  • *
  • Posts: 22
  • Karma: 0
Av28 wood boss runs 5 minutes & dies
« on: August 16, 2019, 02:07:23 pm »
The saw has a new carb, fuel line & filter. Vent is clear. One new crank seal.

It runs full speed for 5 minutes or so than starts bogging down. It will die if cutting continues, but speeds up if not. Compression is good. It has never had any electronics replaced

Air leak? Thanks

Share on Facebook Share on Twitter


Offline ba_50

  • 3 cube
  • *
  • Posts: 22
  • Karma: 0
Av28 wood boss runs 5 minutes then bogs down
« Reply #1 on: August 16, 2019, 07:37:56 pm »
The saw has a new carb, fuel line & filter. Vent is clear. One new crank seal.

It runs full speed for 5 minutes or so than starts bogging down. It will die if cutting continues, but speeds up if not. Compression is good. It has never had any electronics replaced

Air leak? Thanks

Offline Midpines

  • 3 cube
  • *
  • Posts: 9
  • Karma: 2
Re: Av28 wood boss runs 5 minutes & dies
« Reply #2 on: August 17, 2019, 10:53:09 pm »
I had a Poulan 245 doing that while I was trying to tune it up after rebuilding it.  It was flooding the crankcase with fuel until it would splash into the top of the cylinder and drown the spark. i got it under control by leaning out both the L and H needle valves.  I had started with 1 1/2 turns on each as a starting place.  I wound up with L at 1 1/4, and H at 7/8. 

The spark plug was wet right after it would die, that's how I figured it out.   

I had another saw do something like that, in that case the carburetor bowel valve was not closing when the chamber under the diaphragm was full. It was pushing that excess fuel through the jets under pressure.  The little arm which touches the diaphragm was bent, the valve was always held open.

Both saws really used a lot of gas fast. 

 

Related Topics

  Subject / Started by Replies Last post
13 Replies
1298 Views
Last post March 09, 2012, 01:51:34 pm
by eli-dream
9 Replies
971 Views
Last post October 26, 2013, 10:25:33 pm
by 660magnum
2 Replies
466 Views
Last post November 17, 2013, 02:32:04 am
by 660magnum
14 Replies
718 Views
Last post June 08, 2014, 08:00:28 am
by jmester
35 Replies
994 Views
Last post June 25, 2014, 08:39:11 am
by Fish
7 Replies
742 Views
Last post October 29, 2014, 03:58:59 pm
by Fish
31 Replies
947 Views
Last post November 25, 2014, 07:12:07 am
by Al Smith
5 Replies
439 Views
Last post November 12, 2016, 10:08:30 pm
by oldpro
3 Replies
354 Views
Last post July 08, 2017, 02:51:01 am
by snoozeys
5 Replies
311 Views
Last post November 04, 2021, 07:47:45 am
by Cut4fun .