Chainsaw Repair

In 1992 this saw was run at the dealer for a few min, then ran out of fuel and put in the case until I got it this week. It never touched wood.

Is there any chance I can get by with out replacing the diaphragms and or needle. I would at least like to try it before working on it.

It cranks over normally and was kept inside so seems rings and cylinder are fine. Any tips?

Also is there a muffler mod I can make to free up flow with out making too much noise

Thanks.










 

Sounds like a great find wbear!!
I picked up a VG used one this summer.  Have only put a few tanks through it but really enjoying it so far.  Wish I had picked up yours!!!
I'm not an expert, but I agree with Cut4fun2.  ck it out visually, stick some now gas/oil in it & give it a try before you tear it down.  At worst you waste a little fuel.
For muffler mods, look at this post.
http://chainsawrepair.createaforum.com/stihl/differences-between-026-026-pro/