Author Topic: Broken Bar Stud 039  (Read 349 times)

0 Members and 0 Guests are viewing this topic.

Offline bustedknuckles

  • 4 cube
  • **
  • Posts: 70
  • Karma: 11
Re: Broken Bar Stud 039
« Reply #10 on: February 23, 2014, 04:08:33 am »
If it's broken flush with the pan, just disassemble the saw. Less chance of collateral damage that way. I use ice cube tray to put the parts in as I take it apart to I can work backwards when assembling. You will have over 100 parts and pieces on the bench by the time you get the engine out so some method of organization is important if you don't have a photographic memory.

If you use heat to get the stud out, you'll probably want to reseal the pan to the cylinder.

 

Related Topics

  Subject / Started by Replies Last post
stihl bar stud repair

Started by mweba « 1 2 » Stihl

12 Replies
4230 Views
Last post September 09, 2019, 09:42:41 am
by joe_indi
3 Replies
226 Views
Last post August 17, 2013, 10:20:27 pm
by cowroy
5 Replies
629 Views
Last post September 03, 2014, 11:53:37 pm
by 3000 FPS
7 Replies
379 Views
Last post September 02, 2014, 03:29:39 pm
by Nathaniel Vansickle
8 Replies
48 Views
Last post October 07, 2014, 02:36:40 pm
by sharkey
4 Replies
174 Views
Last post April 03, 2015, 09:25:53 am
by wild262
1 Replies
260 Views
Last post January 25, 2016, 11:21:00 am
by srcarr52
2 Replies
383 Views
Last post August 20, 2016, 12:56:41 pm
by jr27236
0 Replies
93 Views
Last post December 20, 2016, 06:35:52 pm
by fisaw
0 Replies
224 Views
Last post September 09, 2019, 09:38:40 am
by joe_indi