« previous next »
Pages: 1 [2]   Go Down

Author Topic: can't get the torx head bolts out of bottom of Stihl ms 310 engine  (Read 671 times)

0 Members and 0 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna
Re: can't get the torx head bolts out of bottom of Stihl ms 310 engine
« Reply #10 on: September 11, 2013, 04:59:24 pm »
I just had the same sort of problem with a ms660 clutch  no matter what I did, even a 1/2 inch air gun would not break it loose. Then I remembered something my father taught me. I set the gun to tighten the clutch ( yes I know it is reverse thread ). One or two burps then set it to remove the clutch and burp burp and it came right off. It has something to do with breaking the thread contact area down by tightening the fastener.
Logged
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
7 Replies
2443 Views 		Last post January 19, 2014, 03:01:25 pm
by 660magnum
7 Replies
1083 Views 		Last post October 03, 2012, 04:40:47 pm
by H 2 H
4 Replies
611 Views 		Last post November 06, 2012, 06:21:39 pm
by Al Smith
1 Replies
301 Views 		Last post November 13, 2012, 07:24:35 pm
by 084
1 Replies
355 Views 		Last post February 23, 2014, 02:25:04 pm
by jmester
14 Replies
780 Views 		Last post June 08, 2014, 08:00:28 am
by jmester
5 Replies
555 Views 		Last post July 08, 2014, 10:47:27 pm
by adam32
3 Replies
210 Views 		Last post July 21, 2015, 01:17:51 pm
by Cut4fun .
5 Replies
590 Views 		Last post January 03, 2016, 10:37:31 am
by 660magnum
1 Replies
553 Views 		Last post March 03, 2018, 09:19:29 am
by Cut4fun .