Author Topic: Clarify the sizes and no's for the Stihl saws  (Read 209 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22580
  • Karma: 591
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Clarify the sizes and no's for the Stihl saws
« on: March 15, 2017, 09:07:36 am »
Poulan 3300 is a 54cc bare bore cylinder saw. Heck of a saw and my dad has owned and used one since late 80's.  Check impulse line very common need on these.  Fuel lines too. Sometimes need a intake boot and rubber av's. I consider this a pro grade saw and will eat a stihl 026 49cc 260 50cc lunch on it's best day. ;)

So skip a 026 260 IMO and jump up to 60cc 70cc pro or 64cc homeowner plastic type saw in stihl to out cut a 3300. JMO   I would look at the used market stihl 036 360 62cc or stihl 361 59cc, skip the OE 362 look for NE T2 362 59cc if looking at 362. Look for 044 440 70.7cc over the 441 IMO.  046 460 461 76.5cc
Homeowner plastic stihl 039 390 64cc or even the 311 newer seems strong for 59cc. But dont see where gaining much cc wise over the poulan 3300 54cc.  391 is 64cc but not very favorable feedback on them.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
276 Views
Last post March 27, 2012, 01:11:06 pm
by Cut4fun .
24 Replies
1576 Views
Last post October 25, 2012, 08:45:50 am
by Al Smith
9 Replies
547 Views
Last post January 24, 2014, 01:18:49 pm
by Cut4fun .
9 Replies
1586 Views
Last post February 02, 2014, 07:45:35 pm
by countryhog
2 Replies
121 Views
Last post April 14, 2015, 08:48:14 pm
by deereguy
0 Replies
383 Views
Last post August 16, 2015, 03:19:40 am
by 660magnum
2 Replies
166 Views
Last post May 07, 2016, 02:39:51 pm
by jmester
New to Stihl saws

Started by roccus « 1 2 » Stihl

10 Replies
281 Views
Last post January 25, 2017, 11:40:38 pm
by roccus
0 Replies
113 Views
Last post February 05, 2019, 08:18:46 pm
by Cut4fun .
16 Replies
747 Views
Last post March 02, 2020, 06:07:10 pm
by Al Smith