Author Topic: Ignition Problems?  (Read 308 times)

0 Members and 0 Guests are viewing this topic.

Offline msc1072

  • 3 cube
  • *
  • Posts: 8
  • Karma: 1
Re: Ignition Problems?
« on: March 21, 2013, 08:19:14 pm »
Clean the kill switch good with some electrical contact cleaner and you might want to check your crank seals. I just had to replace them in one of my Husqvarna saws. It had sorta the same symptoms you described. It would start and idle for short periods then die. If you tried to rev it up it would sound like it was missing (lean hits) and kick back in your hands. I found it was my clutch side crank seal leaking.
A set of new seals and it runs great again.
Good luck

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
623 Views
Last post January 02, 2013, 08:23:58 am
by William Greene
5 Replies
222 Views
Last post January 27, 2013, 11:42:57 am
by Al Smith
6 Replies
1245 Views
Last post June 02, 2013, 09:30:02 pm
by brokenbudget
12 Replies
279 Views
Last post October 19, 2013, 03:30:14 pm
by jmester
26 Replies
369 Views
Last post December 27, 2013, 10:04:20 am
by KilliansRedLeo
27 Replies
393 Views
Last post March 23, 2014, 04:52:19 am
by dutchsawdoctor
8 Replies
729 Views
Last post October 04, 2014, 09:16:30 am
by aclarke
7 Replies
503 Views
Last post December 15, 2014, 05:05:15 pm
by 660magnum
6 Replies
3889 Views
Last post March 04, 2015, 06:47:28 pm
by jmester
9 Replies
186 Views
Last post February 22, 2017, 10:41:26 pm
by RoyM