« previous next »
Pages: [1]   Go Down

Author Topic: Is this piston/cylinder to far gone?  (Read 510 times)

0 Members and 0 Guests are viewing this topic.

Offline mkjt88

  • 3 cube
  • *
  • Posts: 7
  • Karma: 2
Re: Is this piston/cylinder to far gone?
« on: March 01, 2020, 09:24:24 am »
Yes its the 441... The gouges on the exhaust port are fairly deep.. you defiantly get a nail caught on them probably beyond resurfacing. And for the cause im not positive yet. What research i could find and which matched this saw could have been either over heated from gunk build up.. possibly to many cold starts straight to work? Still trying to diagnose that problem not sure where to go next?
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
0 Replies
593 Views 		Last post May 24, 2012, 08:20:22 pm
by MP5N
19 Replies
1739 Views 		Last post September 09, 2013, 09:51:10 pm
by doreadeal
1 Replies
448 Views 		Last post March 11, 2014, 04:13:31 pm
by Cut4fun .
4 Replies
437 Views 		Last post March 06, 2015, 11:28:35 am
by jmester
0 Replies
403 Views 		Last post September 26, 2015, 10:29:23 pm
by 660magnum
12 Replies
2915 Views 		Last post January 12, 2016, 11:14:58 pm
by 3000 FPS
3 Replies
1220 Views 		Last post December 30, 2016, 10:38:16 pm
by sharkey
4 Replies
968 Views 		Last post September 26, 2017, 05:25:54 pm
by pigpen60
1 Replies
2329 Views 		Last post September 20, 2018, 04:08:33 pm
by Cut4fun .
0 Replies
251 Views 		Last post March 28, 2022, 08:09:50 am
by Cut4fun