Author Topic: MS 241CM issue  (Read 243 times)

0 Members and 0 Guests are viewing this topic.

Offline Old Iron Logging

  • Nitro Hotsaw
  • *******
  • Posts: 1134
  • Karma: 82
MS 241CM issue
« on: January 31, 2016, 01:51:30 pm »
Just a heads up, some 241's have an improperly aligned intake boot from the factory. This does not give a proper seal where the impulse tube slides into the boot. We are fixing under warranty. 2 so far.

Share on Facebook Share on Twitter


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22584
  • Karma: 591
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: MS 241CM issue
« Reply #1 on: February 18, 2016, 07:05:12 pm »
Only issue so far?
REDNECK Saw Repair Getter Done

Offline Old Iron Logging

  • Nitro Hotsaw
  • *******
  • Posts: 1134
  • Karma: 82
Re: MS 241CM issue
« Reply #2 on: February 19, 2016, 08:36:29 pm »
Our mechanic was off to Stihl tech school this week. The day was mostly on M-tropics. Didn't get to hear all that was discussed when he returned. One other thing that can be an issue is that the flywheel can get dirty enough to cause the saw to run poorly. Only 1 saw so far but it would not read on the diagnostic until poles were cleaned on flywheel.

My personal 241 has 70 plus tanks on it now. The best small wood pulp saw I have ever owned. My 261 just sets on the shelf now.

Offline Old Iron Logging

  • Nitro Hotsaw
  • *******
  • Posts: 1134
  • Karma: 82
Re: MS 241CM issue
« Reply #3 on: February 21, 2016, 01:21:50 pm »
Started to read some of the literature our tech brought back regarding the Stihl diagnostic tool. Seems it can be used to check for lean conditions on a tradition carb equipped saw. Will check into it more at work tomorrow.
Like Like x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
8 Replies
617 Views
Last post August 30, 2012, 12:53:08 pm
by Remington
22 Replies
718 Views
Last post January 24, 2016, 05:16:42 pm
by Reddog
5 Replies
751 Views
Last post January 25, 2014, 03:07:17 pm
by Infinitive
11 Replies
276 Views
Last post February 09, 2015, 09:32:54 pm
by DexterDay
6 Replies
230 Views
Last post May 19, 2015, 06:53:03 am
by Spike60
8 Replies
129 Views
Last post September 30, 2015, 09:14:25 pm
by jmester
0 Replies
257 Views
Last post October 17, 2015, 03:31:43 pm
by jrdplowing
6 Replies
278 Views
Last post May 09, 2016, 05:25:47 am
by Al Smith
10 Replies
341 Views
Last post October 10, 2016, 08:25:35 am
by Old Iron Logging
3 Replies
155 Views
Last post November 08, 2017, 11:05:17 pm
by super44