Author Topic: MS 250 Very hard to pull wont start!!  (Read 4823 times)

0 Members and 30 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO

  • Total Badges: 39
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary 5000 Posts Third year Anniversary
Re: MS 250 Very hard to pull wont start!!
« Reply #30 on: January 13, 2014, 01:24:31 pm »
So with what you know what could be causing the hard turn? In other words with the flywheel removed turning it, it has spots where it is hard to turn then gets easy and then real hard again.  My limited knowledge I know that during compression stroke that it is hard to turn but this is not that at all.  Could the bearings be out? Crank bent?
I would want to feel that myself? I would take out the spark plug and remove the starter housing and feel of the engine itself without compression?

I would try to move the flywheel in and out and up and down for play?

I would remove the clutch cover, bar, and chain, then check that side for excess play and unusual movement also.
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .

 

Related Topics

  Subject / Started by Replies Last post
14 Replies
1403 Views
Last post October 30, 2013, 08:41:27 pm
by president
10 Replies
1223 Views
Last post February 04, 2014, 03:24:19 pm
by president
MS360 Pro wont start

Started by ears54 « 1 2 » Stihl

10 Replies
1361 Views
Last post August 16, 2015, 03:37:13 pm
by Cut4fun .
2 Replies
496 Views
Last post September 12, 2015, 09:44:05 pm
by jrdplowing
36 Replies
3173 Views
Last post February 11, 2016, 11:17:11 am
by 3000 FPS
4 Replies
1405 Views
Last post November 27, 2016, 08:59:14 pm
by mdavlee .
16 Replies
4259 Views
Last post September 06, 2020, 09:55:48 pm
by Spike60
9 Replies
1349 Views
Last post June 18, 2017, 08:25:10 pm
by Al Smith
13 Replies
1359 Views
Last post October 13, 2017, 05:45:23 am
by mountainlake
1 Replies
391 Views
Last post October 23, 2022, 06:55:03 am
by Cut4fun