« previous next »
Pages: [1]   Go Down

Author Topic: Ms 290 Walbro HD-18  (Read 441 times)

0 Members and 22 Guests are viewing this topic.

Offline sharkey

  • Piped Saw
  • *****
  • Posts: 368
  • Karma: 37

    • Total Badges: 26
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 5
Re: Ms 290 Walbro HD-18
« on: December 30, 2015, 01:34:39 am »
I would raise the lever on that one.  It really isnt where it pops off, it is where it reseats that matters.  It should hold 5-7psi on the reseat and if it doesnt then the inlet seat needs polished.  It also seems to matter that the inlet needle is wet, so either try a little fuel or if the carb is off the saw take it over to the sink.   
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
10 Replies
2235 Views 		Last post November 10, 2017, 12:29:46 pm
by ray benson
3 Replies
666 Views 		Last post November 20, 2013, 06:39:23 pm
by KilliansRedLeo
0 Replies
428 Views 		Last post November 25, 2013, 07:42:14 am
by KilliansRedLeo
3 Replies
479 Views 		Last post December 11, 2013, 11:57:54 am
by farmboy
2 Replies
684 Views 		Last post January 28, 2018, 03:30:51 pm
by 3000 FPS
2 Replies
340 Views 		Last post February 13, 2018, 06:25:28 pm
by Woodsman696
6 Replies
1064 Views 		Last post January 02, 2019, 01:01:25 pm
by trappermike
1 Replies
471 Views 		Last post October 20, 2019, 10:02:38 am
by Cut4fun .
5 Replies
517 Views 		Last post January 29, 2020, 02:39:53 pm
by ENTS
3 Replies
187 Views 		Last post January 17, 2024, 09:18:55 am
by Cut4fun .