« previous next »
Pages: [1]   Go Down

Author Topic: MS290 carb adjust after MM  (Read 543 times)

0 Members and 18 Guests are viewing this topic.

Offline H 2 H

  • 5 cube
  • ***
  • Posts: 100
  • Karma: 11
  • Location: Were the Pacific Northwest Soft Woods Grow

    • Total Badges: 19
    Badges: (View All)
    100 Posts Second year Anniversary Karma Good Level 4 50 Posts One year Anniversary
Re: MS290 carb adjust after MM
« on: October 28, 2013, 01:38:16 pm »
Another way is to use a drill and drill motor and drill the plastic till your hit metal than use screw it till you can get the plastic off the back of the screw

I haven't seen it come out of tune not having the plastic limiter on that screw
Logged
"People ask me where all my money went, I tell them half of it I spent on gambling, fast women and liquor, the other half I wasted!" W.C.

"..... nothing more funnier than watching some ole coot make a fool out of himself, especially sideways”

"You can't argue with someone that doesn't have any real life experience on the subject."
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
MS290 MM

Started by Kenskip1 Stihl

6 Replies
775 Views 		Last post December 24, 2011, 05:38:54 am
by Al Smith
2 Replies
763 Views 		Last post August 10, 2012, 04:17:28 pm
by mweba
6 Replies
644 Views 		Last post April 26, 2013, 01:54:02 pm
by Vance in AK
2 Replies
485 Views 		Last post April 24, 2013, 09:55:29 pm
by Adirondackstihl
ms290

Started by gunrac « 1 2 3 » Stihl

28 Replies
1368 Views 		Last post February 24, 2014, 01:39:48 pm
by Cut4fun
9 Replies
735 Views 		Last post May 17, 2014, 11:06:56 pm
by Jason K
3 Replies
353 Views 		Last post August 15, 2014, 11:59:14 am
by Cut4fun
6 Replies
568 Views 		Last post November 02, 2015, 07:43:33 pm
by Al Smith
15 Replies
600 Views 		Last post May 28, 2020, 10:39:55 am
by Cut4fun .
5 Replies
532 Views 		Last post May 10, 2022, 11:29:50 am
by 3000 FPS