« previous next »
Pages: [1]   Go Down

Author Topic: MS290 Parts problem  (Read 392 times)

0 Members and 0 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4688
  • Karma: 319
  • Location: Carpenter, Wyoming
Re: MS290 Parts problem
« on: May 10, 2022, 11:29:50 am »
Quote from: Cut4fun . on May 10, 2022, 07:31:49 am
Did you buy saw new?  If not lot of guys used to use 044 440 intake boot and carbs. What carb you have on it. 

Dont know if this is the case but just a W.A.G.

I think you are correct.   Someone has made a change to the saw using a larger intake.   That is quite a difference in size between the two intakes.
Logged
PP 505, 475, 445.
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
MS290 MM

Started by Kenskip1 Stihl

6 Replies
624 Views 		Last post December 24, 2011, 05:38:54 am
by Al Smith
2 Replies
656 Views 		Last post August 10, 2012, 04:17:28 pm
by mweba
6 Replies
484 Views 		Last post April 26, 2013, 01:54:02 pm
by Vance in AK
ms290

Started by gunrac « 1 2 3 » Stihl

28 Replies
1001 Views 		Last post February 24, 2014, 01:39:48 pm
by Cut4fun
Stihl MS290

Started by Buddy Stihl

8 Replies
538 Views 		Last post March 25, 2014, 05:27:17 pm
by Buddy
MS290 won't run slow

Started by jvh24521 « 1 2 3 » Stihl

25 Replies
856 Views 		Last post March 11, 2014, 03:29:25 pm
by jvh24521
1 Replies
243 Views 		Last post March 22, 2014, 02:33:52 pm
by gunrac
2 Replies
331 Views 		Last post July 06, 2014, 08:25:56 am
by bardos
6 Replies
191 Views 		Last post March 23, 2018, 08:00:40 pm
by ray benson
3 Replies
242 Views 		Last post August 15, 2014, 11:59:14 am
by Cut4fun