Author Topic: MS390 - problem after locking crank to remove flywheel and change oil pump? Help.  (Read 563 times)

0 Members and 22 Guests are viewing this topic.

Offline Le Maisonniau

  • 3 cube
  • *
  • Posts: 14
  • Karma: 2
  • Location: France

  • Total Badges: 24
    Badges: (View All)
    Level 5 Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Karma Good Level 4
 :)  Plug's OK, it wasn't in at the time.  It is difficult with this m/c to check the spark too, I will see what I can cobble up to see if it is sparking.
cheers

But then again, the bit of line left in may have closed up the gap, so thanks, I'll check that.  ::)
Retired in France

 

Related Topics

  Subject / Started by Replies Last post
44 Replies
4740 Views
Last post February 25, 2012, 10:26:16 pm
by CASE5854x4
4 Replies
1356 Views
Last post April 02, 2012, 09:31:29 am
by 2spud
55 Replies
10864 Views
Last post September 21, 2015, 07:42:19 pm
by mikehonda
6 Replies
769 Views
Last post October 11, 2013, 08:32:02 am
by Fish
8 Replies
334 Views
Last post February 03, 2014, 11:37:09 am
by theoldman
1 Replies
394 Views
Last post August 22, 2014, 08:33:48 pm
by 660magnum
4 Replies
400 Views
Last post November 22, 2014, 12:00:58 am
by 660magnum
2 Replies
519 Views
Last post December 16, 2015, 02:04:51 pm
by Randy
3 Replies
777 Views
Last post March 18, 2016, 09:02:35 am
by Jason K
3 Replies
414 Views
Last post February 08, 2018, 08:50:19 pm
by mdavlee .