« previous next »
Pages: [1]   Go Down

Author Topic: Problem starting my ms290  (Read 440 times)

0 Members and 44 Guests are viewing this topic.

Offline bardos

  • pruner
  • *
  • Posts: 2
  • Karma: 0

    • Total Badges: 4
    Badges: (View All)
    Topic Starter Level 1 First Post Windows User
Problem starting my ms290
« on: July 06, 2014, 07:44:54 am »
I don't use the chainsaw all that much. I leave i laying around a lot. Anyway, just a few days ago I went to start it up and it fired fine. The the day after there was no way it would fire. So I leave it for a day or two and then it starts up fine. I have had this problem for a while now and I bring it in to my local chainsaw person who will clean filters, carb abd change my plug... blah blah blah... but then it reverts to the same behaviour. Any advice? thanks
Logged

Share on Facebook Share on Twitter

Offline sharkey

  • Piped Saw
  • *****
  • Posts: 368
  • Karma: 37

    • Total Badges: 26
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 5
Re: Problem starting my ms290
« Reply #1 on: July 06, 2014, 08:18:35 am »
Dump the old fuel mix that has been sitting out in the garage all winter into the truck/car.  Always start with fresh fuel mix, that you mixed yourself.  Then when your done using the saw, dump the fuel mix back into the can and run the carb dry.  This keeps any varnish or ethanol separation from happening.  If you store it dry, it should be a couple pull starter every time you need it. 
Logged

Offline bardos

  • pruner
  • *
  • Posts: 2
  • Karma: 0

    • Total Badges: 4
    Badges: (View All)
    Topic Starter Level 1 First Post Windows User
Re: Problem starting my ms290
« Reply #2 on: July 06, 2014, 08:25:56 am »
thanks, that sounds like great advice. will do.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
12 Replies
2063 Views 		Last post December 11, 2014, 02:51:35 am
by Hoggwood
5 Replies
1664 Views 		Last post July 04, 2012, 05:29:50 pm
by SawTroll
ms361 not starting

Started by haasper « 1 2 3 » Stihl

22 Replies
3467 Views 		Last post December 28, 2012, 04:42:43 pm
by 660magnum
3 Replies
461 Views 		Last post February 20, 2013, 04:39:47 pm
by Cut4fun .
21 Replies
1063 Views 		Last post July 27, 2014, 06:12:27 pm
by JohnG28
0 Replies
276 Views 		Last post June 20, 2015, 12:02:22 pm
by Cut4fun .
6 Replies
1755 Views 		Last post December 23, 2016, 04:52:43 am
by DNX800
1 Replies
366 Views 		Last post October 17, 2019, 12:37:20 pm
by Cut4fun .
5 Replies
535 Views 		Last post May 10, 2022, 11:29:50 am
by 3000 FPS
1 Replies
24 Views 		Last post April 04, 2024, 06:32:18 am
by Cut4fun .