Author Topic: rebuilt 066 wont run  (Read 385 times)

0 Members and 0 Guests are viewing this topic.

Offline jmester

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2083
  • Karma: 161
  • Location: MD
Re: rebuilt 066 wont run
« Reply #10 on: February 18, 2014, 07:10:32 am »
The metal flywheels that I have seen are a 2 slot flywheel, do you have it in the right slot. Believe it should be in the x marked slot. I would check your flywheel key. And also check your coil gap. Have seen saw where the flywheel was not properly installed and it spin past the key and make the saw act crazy.
FEAR NO TREE. FEAR GOD.

 

Related Topics

  Subject / Started by Replies Last post
9 Replies
1272 Views
Last post November 05, 2014, 10:35:55 pm
by 67L36Driver
13 Replies
396 Views
Last post November 04, 2013, 05:27:49 am
by alsled
5 Replies
313 Views
Last post April 13, 2014, 11:22:26 am
by KilliansRedLeo
4 Replies
288 Views
Last post July 12, 2014, 05:55:01 pm
by KilliansRedLeo
MS360 Pro wont start

Started by ears54 « 1 2 » Stihl

10 Replies
568 Views
Last post August 16, 2015, 03:37:13 pm
by Cut4fun .
2 Replies
199 Views
Last post September 12, 2015, 09:44:05 pm
by jrdplowing
36 Replies
1591 Views
Last post February 11, 2016, 11:17:11 am
by 3000 FPS
2 Replies
390 Views
Last post December 30, 2015, 03:58:15 pm
by Cat-Face Timber
10 Replies
589 Views
Last post April 09, 2017, 03:28:22 pm
by HolmenTree
11 Replies
2307 Views
Last post June 05, 2017, 02:48:32 pm
by 3000 FPS