Author Topic: Squish  (Read 2482 times)

0 Members and 0 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2753
  • Karma: 170
Re: Squish
« on: August 11, 2012, 09:42:35 am »
Early on I basically did about the same and it did cut faster .Although instead of sealant I cut the cylinder bases on a lathe .It was only later with a couple of models I later went in and did some tweeking to the ports to jack up the  speed a tad bit .

You know this method really isn't a bad way to jack some power with very little effort .This and a little muffler work would provide very satisfactory to 90 percent of folks who want just a little more grunt but don't feel like ponying up a couple hundred to get someone to soup it up .Once again proving you don't have to be a bloody genious to pep up a saw engine .

What the heck if it didn't work out just put the gasket back in and you're right back to where you started .Full circle so to speak . ;)

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
109 Views
Last post January 02, 2014, 07:51:46 pm
by Al Smith
17 Replies
222 Views
Last post January 22, 2014, 11:37:54 pm
by aclarke
9 Replies
346 Views
Last post December 15, 2014, 05:11:31 pm
by 1manband
1 Replies
164 Views
Last post January 02, 2016, 09:58:46 am
by weimedog