Author Topic: Stihl 028 woodboss not starting  (Read 573 times)

0 Members and 32 Guests are viewing this topic.

Offline tfox1994

  • pruner
  • *
  • Posts: 3
  • Karma: 2

  • Total Badges: 6
    Badges: (View All)
    Level 2 Karma Topic Starter First Post Level 1 Windows User
Stihl 028 woodboss not starting
« on: August 14, 2017, 12:36:15 pm »
About a year ago I began trying to fix an old 028 woodboss that had been sitting for about 10 years. I rebuilt the carb and it ran fine for awhile but then it wouldn't shut off (I would switch it off and it just wouldn't quit) so I replaced the ground wire and now it won't start at all unless I put a little fuel in with the spark plug and then it'll only run for 10 seconds or so and if I try to give it throttle it will die. I have taken off the fuel and impulse lines and they are not plugged nor leaking. I have cleaned the carburetor, I made sure the spark plug had a spark, and it seems like it has good compression because it will start for a few seconds with a little gas put in the spark plug hole. Any advice would be greatly appreciated, thank you.

Share on Facebook Share on Twitter


Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Stihl 028 woodboss not starting
« Reply #1 on: August 14, 2017, 06:43:54 pm »
Well it could be that the diaphragms in the carb have gone bad and it is no drawing any fuel.   I would put a kit in the carb and look the fuel line over real careful for any cracks in it any where.     The corrugated part of the fuel line is real good about hiding cracks.   
PP 505, 475, 445.
Like Like x 1 View List

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23708
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

  • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: Stihl 028 woodboss not starting
« Reply #2 on: August 14, 2017, 06:53:19 pm »
Check impulse line too.


Offline tfox1994

  • pruner
  • *
  • Posts: 3
  • Karma: 2

  • Total Badges: 6
    Badges: (View All)
    Level 2 Karma Topic Starter First Post Level 1 Windows User
Re: Stihl 028 woodboss not starting
« Reply #3 on: August 15, 2017, 01:55:38 am »
I have a new carb on the way and I checked both the fuel and impulse lines and they seem to be fine, but if the carb does not work I will try replacing them

Offline snoozeys

  • 3 cube
  • *
  • Posts: 17
  • Karma: 1

  • Total Badges: 3
    Badges: (View All)
    Windows User Linux User Mobile User
Re: Stihl 028 woodboss not starting
« Reply #4 on: August 17, 2017, 10:56:49 am »
My 028 is a lovely saw but is an absolute nightmare to start and refuses to idle !!!

Sent from my SM-G925I using Tapatalk


Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Stihl 028 woodboss not starting
« Reply #5 on: August 17, 2017, 11:43:39 am »
My 028 is a lovely saw but is an absolute nightmare to start and refuses to idle !!!

Sent from my SM-G925I using Tapatalk



There probably is something that can be fixed.   It could be the crank seals, or the fuel line and filter, or the carburetor.   I would start by seeing if the carb can be adjusted to make it idle and go to wide open throttle without bogging down.   
PP 505, 475, 445.

Offline tfox1994

  • pruner
  • *
  • Posts: 3
  • Karma: 2

  • Total Badges: 6
    Badges: (View All)
    Level 2 Karma Topic Starter First Post Level 1 Windows User
Re: Stihl 028 woodboss not starting
« Reply #6 on: August 28, 2017, 01:01:34 am »
Bought an aftermarket carb off ebay and now it runs great.
Like Like x 1 Winner Winner x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
1641 Views
Last post July 04, 2012, 05:29:50 pm
by SawTroll
ms361 not starting

Started by haasper « 1 2 3 » Stihl

22 Replies
3440 Views
Last post December 28, 2012, 04:42:43 pm
by 660magnum
3 Replies
457 Views
Last post February 20, 2013, 04:39:47 pm
by Cut4fun .
12 Replies
5810 Views
Last post March 10, 2013, 06:29:23 am
by Al Smith
0 Replies
202 Views
Last post March 07, 2013, 05:53:02 pm
by CG Racing
21 Replies
1044 Views
Last post July 27, 2014, 06:12:27 pm
by JohnG28
2 Replies
432 Views
Last post July 06, 2014, 08:25:56 am
by bardos
0 Replies
273 Views
Last post June 20, 2015, 12:02:22 pm
by Cut4fun .
10 Replies
837 Views
Last post August 30, 2022, 10:22:35 am
by ray benson
6 Replies
1726 Views
Last post December 23, 2016, 04:52:43 am
by DNX800