Chainsaw Repair

I'm putting one of these back together and the clutch drum seems to have way too much play, nearly 1/8 of an inch.  As per the ipl all the parts are in the correct order but it seems to need an extra washer as a spacer on the drive shaft.  There is a shoulder on the shaft which stops the clutch drum (rim drive) from going any closer to the oiler drive washer.  Do I have the wrong drum perhaps.  This is a new to me old saw that was/is in rough shape.  Don't know why I'm spending so much time and $ on it.  Any thoughts welcome

Regards,

Lee

Yes it has the hole for the oiler drive pin.  Thanks for your input

Lee

If it is an aftermarket sprocket I would say that where the problem is. To me there tolerances are not as stringent as oem . I think that most saws have a little inward/outward play an least a 1/16th.

Thanks for the input. I re looked at the service manual and discovered that I had the oil pump driving washer on backwards and now all is well.

Thanks again

Lee

So I have a good spark and good comp but no fire! I guess maybe the timing is off. Although I'm sure I got it to fire a while ago?

Any thoughts?

 :-\Lee