Chainsaw Repair

Stihl 034 AVS

034 Super the early one coming in. Recall the early info on pulley pawls etc.


Per Dave

All of the following technical bulletins relating to the 034, 034 Super and 036


034 and 036 technical bulletin summary

June 21st, 1995 - TI 28.95 - modified tank housing and tank vent, new muffler, retainers for fuel and oil caps, flywheels and heating elements for heated model

July 7th, 1995 - TI 30.95 - new decomp cylinder, compensating air filter, air filter carburetor, carb box, shroud, tank housing, spark plug terminal



T.16.87 - new Super 034, new cylinder, crankshaft, piston, crankcase, carb, etc, many changes for new model.

T.7.87 - new handlebar strengthener, flywheel, clutch springs, oil pump, other minor changes

T.45.86 - heating system changes, new clutch washer versions, new impulse line

T.39.86 - new oil pump worm spring, oil pump hose sleeve, winter shroud, rope rotor, longer muffler mounting screws


T.35.84 (T.28.84) - 13 page intro to 034 chainsaw and series 1125

T.30.85 (T.31.85) - new shroud for carb preheating shutter, new AV buffers, new impulse line, new carburetor parts and jet size

T.17.85 (T.11.85) - new carburetor, clutch springs, change to planned coil modification already in printed literature, correction of choke lever part number

034

1128 195 0400 rotor   1125 195 0401
1125 195 7200 pawl
1128 195 3500 spring double
0000 958 0923 washer  0000 958 0806
1118 195 3500 single

036

1128 195 0400 pulley
1125 195 7200 pawl
0000 958 0923 washer
1128 195 3500 spring double


361

1128 195 3500 spring
0000 958 0923 washer
1128 195 0400 rotor
1125 195 7200 pawl

Stihl 034 super original owner. Just got to tell the story so others dont make same mistake he did.

Complaint was hard to start. Ask what all it did and he runs e-free so thats a good thing.  He said he pulled the plug and cleaned and gap per manual.

I was like last time that saw was in pretty sure I put new plug in it so gap was right.  I said show me where you gapped it on my gap tool as I was pulling plug. .050 he showed me on the tool. He says per his manual that came with saw. I showed him manual online it says .5mm.

So then I go outside to start it. notta nothing. I'm like it have mix? Sure should have plenty. Open cap notta. So put some of my efree 40:1 vpracing in it and low behold she fires off. Shut off and tryed again from on started again.

Check the small things folks as owners. Double check your reading it right etc too.

So now I have left with 10 freaking chains to do for him grrrrrrr. I hate doing chains and it's repetition crap.