Chainsaw Repair

The typical occasional firewood cutter keeps getting his chain sharpened at the dealer but no one does the rakers. Eventually they consider the chain is getting old and the teeth are short and they accept that the chain's worn out and they buy a new chain. Never any clew about the rakers. They do not know that the chain actually cuts better with the short cutters as long as the rakers are set properly.

Part came in from CCC Dave and installed. Cleaned AF, tank vent etc etc. Carb tuned and ready to go IMO.

Noticed it has went to a E3 plug. Myself I think a gimmick.

 I also noticed carbon tracking under the loose screw on cap part of spark plug. I tightened as good as I could. I told him I would change it if I was him and have plug on hand. But told him it was still working and he basically blew it off conversation.  No biggie to me. So what do you all think of those plugs?

They cost three prices and are nothing but a bunch of hipe.

He'll be back when it won't start. Probably blame you that you did something to it?

Back when I was little, dad worked for Oldsmobile dealer.  Always pulled a plug on customer car that was missing or not running right.  Often found gimmic plugs and just replaced them with the correct AC.  Fixed!

Guess I need to figure out what this 034 has for clutch and needle bearing for the future.   

00 997 0909 3 Tension spring
1125 162 0801 3 Clutch shoe

9512 933 2380 1 Needle cage 10x16x12
9512  933  2260       1  Needle cage 10x13x10 ⇥ 1 49 402 334 (55.2000)
9512  933  2381       1  Needle cage 10x16x12 (B)
9512  003  2260       1  Needle cage 10x13x10 (B) ⇥ 1 49 402 334 (55.2000)

27 162 3200 1 Carrier
27 162 3000 3 Retainer

125 162 3201 1 Carrier (34.2000)
125 162 3000 3 Retainer (34.2000)

Ah yes I remember it well .I got that thing from a tree service .They had ran the tar out of it with a bad air filter ,nothing left of it but the wires,flocking gone .I screwed up the cylinder with a flap wheel so 036 top,after market piston .
I only ran that thing about 15 minutes before the trade deal and often wondered what became of it .It doesn't surprise me after this time if it doesn't need seals .