Chainsaw Repair

I came up with a idea to get some test cuts on the 036.

 I took the new needle bearings out of broken cage and put them in the old clutch bearing cage snapping them in. Only a few wouldnt just snap in and hold.  Then used bearing grease around it.


I filled the oil tank up to check the orange cap out for you. It screwed on perfect and sealed perfect. 




Checked some other things while in there, needs worm gear, oiler spring, clutch drum has some play, rim, decomp,  could use a new piston kit as shown in pic, but ran fine with 140psi.  Could just clean up and re-ring too.






As far a muffler mod on this 036. There is no inner cage to open up or remove. I would just open exhaust outlet on side or use front cover and make a dual port cover out of it.