Author Topic: ms261c  (Read 133 times)

0 Members and 0 Guests are viewing this topic.

Offline aclarke

  • Nitro Hotsaw
  • *******
  • Posts: 1676
  • Karma: 172
ms261c
« on: September 11, 2014, 05:30:04 pm »
Picked up a ms261c the other day and pulled the carb (C1Q s229) off to get an idea of how the fuel is being metered.  Thought it had a Throttle position sensor but the position sensor is hooked up to the choke shaft. There is a small electronic metering device the us fe via two feeder holes under the metering diaphragm. Looks like the metering unit regulates high speed and low speed, although there is a fixed brass inlet orifice leading from the metering unit to the low speed Welch cavity.  I'll put a multimeter on the choke shaft position sensor and check if its varying current to the fuel regulator or if it's simply an on/off swith for the metering unit. 

Anyone else get a grasp on this carb yet? Seems pretty simple so far

Share on Facebook Share on Twitter


 

Related Topics

  Subject / Started by Replies Last post
6 Replies
485 Views
Last post December 08, 2017, 11:56:14 am
by HolmenTree