Chainsaw Repair

ok thanks is it possible that if it is out of time by a one number will it do this same problem and not let it get max WOT? i got the points set at .015 and the manual i got says they should be set .016.

oh i c well i might go a head and buy a other rebuild kit and see what i can do with it. i tried everything i know and it still isn't running like it should.

oh ok i'll check and see what i can get tomarrow hoep fully it won't be to much for a new carb for this saw.

Well here's a update on My stihl 041 farmboss. I got to working on it again and i think i figured out what i done wrong when i was setting the points. well i went out to my shop to reset them and make sure they was right on .016 and they was on .015 well i made sure they set right on .016 and then i found out what i have done when i cleaned them. i wasn't looking pastt he points to the base and i didn't know that base moves when you loosin the screw.well to make a long story short i made sure i put the screw dead center on the base of the points and then went in out there and gave it a good crank and SHE FIRE RIGHT OFF and ran good. i then retuned it and now it will hit the first pull of the rope. but now i have to find me a new clutch and air filter for it and she will be cutting wood once again.

So thanks everyone for trying to help me i sure do appericate it.if it quits raining i'll get a video of it running again.

Yes it's good to get it running again like it should. but only thing i have to find now is the probly a whole new clutch system and a air filter and a flywheel fan. i already got the the flywheel i just need the the fan that 3 screws holds it on. i been searching e-bay but no luck on that and i searched a few other places and no luck there.i even checked with my dealer and he said that i was out of luck on them.but i might get lucky and find one someplace.but with all that it runs like a new one again.