Author Topic: Stihl 046 460  (Read 2251 times)

0 Members and 0 Guests are viewing this topic.

Online 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4548
  • Karma: 292
  • Location: Carpenter, Wyoming
Re: Stihl 460
« Reply #60 on: May 19, 2020, 03:01:44 pm »
So the MS 460 that I bought from AClarke about 5 years ago started running funny on me.    I started to take it apart and found the cylinder was loose.   So I tightened it back up and it seem to be alright and then started running funny again.   So I replaced the crank seals and still running funny.   So yesterday I pulled the cylinder off and removed the base gasket.   Squish was at .022".    This was a woods ported saw and it gave me a chance to check out the porting. 
I will say someone did some nice work it.   Nothing fancy but some nice woods porting.   I like what I saw.   Put it back together yesterday and ran it today.   The base gasket must of had a leak because all back to normal, but I feel the compression difference now.    Nice work Adam even if it is 5 years later.
Thanks.
PP 505, 475, 445.
Like Like x 1 Winner Winner x 1 View List

 

Related Topics

  Subject / Started by Replies Last post
Stihl 026 260

Started by Cut4fun « 1 2 ... 9 10 » Stihl

98 Replies
6954 Views
Last post May 13, 2019, 03:00:53 pm
by Cut4fun .
10 Replies
3455 Views
Last post April 09, 2011, 10:43:48 am
by wannab12
Stihl 034

Started by Cut4fun « 1 2 ... 8 9 » Stihl

82 Replies
4860 Views
Last post April 23, 2019, 01:19:02 am
by Aussie
2 Replies
1498 Views
Last post March 21, 2011, 08:19:57 pm
by Cut4fun
2 Replies
710 Views
Last post March 29, 2011, 03:56:16 pm
by Cut4fun
066 Stihl

Started by man of stihl « 1 2 3 4 » Stihl

30 Replies
2564 Views
Last post September 27, 2015, 08:07:15 am
by Cut4fun .
Stihl 034

Started by Cut4fun « 1 2 » Stihl

10 Replies
1012 Views
Last post July 07, 2012, 04:41:10 am
by brokenbudget
0 Replies
119 Views
Last post December 26, 2013, 09:27:16 am
by jsbirsette6715
0 Replies
353 Views
Last post December 26, 2013, 09:50:16 am
by Cut4fun .
10 Replies
2925 Views
Last post May 02, 2019, 01:09:56 pm
by Cut4fun .