Author Topic: Stihl 150 TC  (Read 617 times)

0 Members and 0 Guests are viewing this topic.

Offline stubnail67

  • 6 cube
  • ****
  • Posts: 180
  • Karma: 23
Re: Stihl 150 TC
« Reply #10 on: February 18, 2018, 03:27:29 pm »
No i dont think so ... looking at the back of it and where the stuff was inside the filter seems to be pulling through where it goes on the carb neck /lip/ring? and not along the filter seams/edge....why i thought a rubber o-ring would work under some compression to seal it off...it must not have sealed near as good as i thought it would....will try grease next then silicon if i have to....i could blow it off quite a few times till i needed to wash it....

 

Related Topics

  Subject / Started by Replies Last post
2 Replies
1328 Views
Last post March 21, 2011, 08:19:57 pm
by Cut4fun
stihl 066

Started by tradguy « 1 2 3 » Stihl

20 Replies
1703 Views
Last post March 11, 2012, 01:25:23 pm
by tradguy
STIHL 441 C-M

Started by man of stihl « 1 2 3 » Stihl

25 Replies
1766 Views
Last post March 14, 2012, 08:53:30 pm
by WoodChuckr
7 Replies
692 Views
Last post May 20, 2012, 05:15:22 pm
by Cut4fun .
Stihl 034

Started by Cut4fun « 1 2 » Stihl

10 Replies
730 Views
Last post July 07, 2012, 04:41:10 am
by brokenbudget
Stihl 064

Started by Cut4fun « 1 2 » Stihl

13 Replies
979 Views
Last post July 28, 2012, 11:17:28 pm
by Cut4fun .
1 Replies
572 Views
Last post August 21, 2012, 09:34:17 pm
by rms61moparman
4 Replies
534 Views
Last post December 13, 2014, 09:25:41 am
by Cut4fun .
Stihl MS 290 390

Started by H 2 H « 1 2 » Stihl

11 Replies
1096 Views
Last post January 22, 2014, 07:27:43 pm
by northern boy
0 Replies
285 Views
Last post December 26, 2013, 09:50:16 am
by Cut4fun .