Chainsaw Repair

Where does the ms290 fit in on this chart?

Came across this. Might help someone.

5910 007 2205 AS crankshaft tool (clutch side removal/installation)
5910 007 2200 ZS crankshaft tool (ignition side removal/installation)
0000 890 1711 Testing Pressure/Vacuum kit (has a couple small pieces missing, like the two small tubes)
5910 890 4400 Oil Seal Puller with 3 sets of jaws
1111 890 6400 Ignition air gap gauge
1110 890 4500 small flywheel puller for most saws up to 046 and old style 066
1106 890 4501 large flywheel puller for the larger saws like new 066, 084 088 076 etc
0000 893 2600 piston ring clamp
0000 893 5903 piston stop
1108 893 4800 wood install block
Torx screw T handle wrench
Exhaust block/gasket for 026-046 saws
old style clutch wrench

Oil Seal Installation Tools
1115 893 4600 for 046, 045 056 and more
1118 893 2401 for 028, 024 , 026, 034, 036, 044
1124 893 2400 for 084 and 088
1127 893 2400 for 038, 084, 088, 064, 066, 029, 039 (used to be 1119 893 2401 but was renumbered)
1121 893 2400 for 024, 026, 034, 036
1128 890 3900 for 044, 064 066
Also 4 sleeves that fit against crankshaft under these on the clutch side

Bearing removal/install tools
1124 893 7200 for 084 088
1118 893 7200 for 028 024 026 034 036 044 046
1122 893 7200 for 064 066
1120 893 7200 for 044 046 009 010 011 012
1119 893 7200 for 038 066 064

I cant remember the stihl 460 rescue handle D ring starter handle part number. Anyone so we can help the guy with the dolmar.

Found it 1128-195-3401 for the stihl 460  rescue handles. $4 to $7 depending on dealer.


 

Ok I gots to get me one of those pull handles for my 034, I should be able to walk into my local dealer with the part number right? No reason I couldn't use that on any saw I wanted???

Thanks man, glad to be here lots of knowledge.

Bearing removal/install tools
1124 893 7200 for 084 088
1118 893 7200 for 028 024 026 034 036 044 046
1122 893 7200 for 064 066
1120 893 7200 for 044 046 009 010 011 012
1119 893 7200 for 038 066 064

These will also work on most of the pro husky saws as well. Used the 1119 893 7200 to put the crank bearings in my 394 case. Not as press mandrel like they are made but just as a holder for the bearing so I don't burn my fingers on the case. They are also fairly inexpensive.