Author Topic: Swap anyone? 084 crankshaft for 088  (Read 179 times)

0 Members and 1 Guest are viewing this topic.

Offline AussieRedGum

  • 3 cube
  • *
  • Posts: 5
  • Karma: 0
  • Location: Western District, Victoria, Australia
Re: Swap anyone? 084 crankshaft for 088
« on: October 08, 2013, 11:15:41 pm »
if the taper is the only difference can you use the 084 crank in the 088 and just run the 084 flywheel???????

I was thinking the same thing but no luck, the shaft on that side is also shorter, not much but shorter and I could use the 084 flywheel, but then I found out the pull start sat too proud to engage on the other side. I guess I could see if the pull start of the 084 would work?

I am also entirely unsure if the 084 flywheel will work with the coil on the 088, would you know? Any knowledge is appreciated!

Cheers!

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1255 Views
Last post February 28, 2015, 11:59:49 am
by Cut4fun
1 Replies
220 Views
Last post October 29, 2013, 07:26:02 pm
by 660magnum
0 Replies
66 Views
Last post January 11, 2014, 01:51:50 pm
by KilliansRedLeo
28 Replies
1337 Views
Last post February 15, 2014, 04:41:31 am
by tassin85
7 Replies
1091 Views
Last post April 08, 2017, 05:46:56 am
by brokenbudget
3 Replies
200 Views
Last post October 21, 2014, 06:33:38 pm
by dolmar
8 Replies
212 Views
Last post March 16, 2015, 12:38:01 pm
by 660magnum
3 Replies
296 Views
Last post February 04, 2016, 07:11:39 am
by Chainsawr
2 Replies
149 Views
Last post November 27, 2017, 12:30:14 am
by weimedog
4 Replies
159 Views
Last post February 21, 2020, 04:26:07 pm
by Cut4fun .