Refi

Author Topic: Top of piston has....  (Read 350 times)

0 Members and 0 Guests are viewing this topic.

Offline David Young

  • 5 cube
  • ***
  • Posts: 133
  • Karma: 16
Re: Top of piston has....
« Reply #20 on: September 25, 2015, 11:38:22 am »
Don't feel so bad about not being able to work on the saw in a timely manner .I've had some it took me months to finish .

got ya beat Al, some of mine have sat for years. 

as for carbon I use a razor blade with a raking angle and a little pressure.  some will remain but will get the bulk of it.  I use compressed air or a rag or rinse in old gas then a wipe or blast of air to get the piston clean


Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21945
  • Karma: 532
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Top of piston has....
« Reply #21 on: September 25, 2015, 02:29:31 pm »
Don't feel so bad about not being able to work on the saw in a timely manner .I've had some it took me months to finish .

got ya beat Al, some of mine have sat for years. 




Got a few projects going on forever myself right now.  Just hard to get into them when I already have same saws running.

Now if it is someone else's saw I get it right back out there.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
15 Replies
448 Views
Last post December 17, 2012, 12:02:09 pm
by Remington
9 Replies
217 Views
Last post March 04, 2015, 03:15:47 pm
by GCC
4 Replies
211 Views
Last post December 15, 2015, 10:18:08 am
by dannyupsolate
2 Replies
222 Views
Last post April 22, 2016, 03:54:11 am
by sharkey
3 Replies
291 Views
Last post July 07, 2016, 09:54:36 pm
by mdavlee .
10 Replies
272 Views
Last post October 28, 2016, 04:23:19 pm
by Cut4fun .
028S - worn piston

Started by qigley « 1 2 » Stihl

19 Replies
313 Views
Last post November 23, 2016, 10:54:26 pm
by oldpro
23 Replies
315 Views
Last post December 19, 2016, 05:37:23 am
by trail twister
6 Replies
429 Views
Last post September 14, 2017, 05:12:38 pm
by mountainlake
12 Replies
289 Views
Last post May 23, 2017, 01:51:26 pm
by Cut4fun .